Cabin Foam

While waiting for parts for the Carver boat, I finished foaming the hull. I used 1800 board feet of material to foam the forward hull area, and Id guess I have a net of 2+ inches on average, maybe closer to 3". As you can see from the pictures, I foamed down to the water line. I did not want to foam below the water line, but I did add insulating beads into my paint to try to minimize condensation below the water line. I did not have enough to foam the anchor chain locker, so Im going to buy a small 200 board foot kit to foam that area. I was really not ready to foam the anchor locker as Ive yet to paint the floor of the chain locker with a rubberized product. I think something like bed liner is what Ill be using to coat the chain locker floor. I will probably also fiberglass over the foam in the chain locker to help protect the foam from getting destroyed by the chain.

I decided to wire the boat after the foaming as I was not too keen on burying wire in the foam. I know Ill have a little bit of a fight getting conduits and wire in now that the foam is in place, but I did spend a day gluing cleats to the hull in strategic spots so Id be able to attached wires, water lines, hydraulic lines and conduits. My plan as of now, is to keep all my electrical stuff up in the ceilings, and all my water and hydraulic lines lower in the hull below the water line. Im going to try and use conduit as much as possible, but Im not opposed to stapling some wires to the framing. My biggest concern is to protect everything and be aware as to not run a screw through any wire as I finish the interior.

Im going to foam the anchor locker myself. Im too far into the foam to bring in a contractor to do such a small job as the chain locker, but I will not do the wheel house and salon myself. Ill be bringing in a contractor to finish those areas some time next year. While Im foaming the chain locker, Im going to foam the engine side of the engine room door. Right now, the engine room door is my weak link in sound deadening, and with a foam job( or left over rock wool), and some sort of liner, I think Ill be able to quadruple its sound rating. Ill have a little engineering involved in keeping the doors grease fittings accessible, but Im not to worried about figuring that one out. My main goal with the engine room door is to give it the ole college try and see what I can do about minimizing sound transmission. If you look at the picture of the engine room door, you can see how thick that wall has become...thick with insulation ( about 7").

The difference in the hull is amazing now that the foam is in. Not only is it much more quiet, the temperature difference is much more noticeable. Once I close things up with the hatch and port lights, I doubt Ill be able to hear any outside noise.

I purchased my foam from www.betterenergy.com, and I was totally happy with the service I got from Michael.

Related Posts by Categories